Arb RD87 Manual de usuario descargar pdf (Pagina 6)

1 Introduction

1.2 Tool-Kit Recommendations

Below is a list of tools and supplies you may need to complete this

installation. Requirements for your vehicle may vary. Please consult

your vehicle service manual for additional recommendations.

1.2.1 Tools

c Standard automotive sizes (metric and/or imperial) of sockets,

wrenches, Allan keys, and drills.

c A dial indicator or other suitable measuring tool for checking ring &

pinion backlash.

c An adjuster-nut wrench. (See your vehicle service manual.)

c A razor knife suitable for cutting nylon tubing.

c A torque wrench. (See your vehicle service manual for the required

torque range.)

c A lubricant drain reservoir.

c A 11.2mm [7/16”] drill and ¼”NPT tap for bulkhead fitting

installation.

c An automotive bearing puller (2 jawed is recommended) or a

differential carrier bearing puller.

c A slide hammer.

c A bearing press or arbor press.

1.2.2 Supplies

c Thread lubricant/sealant compound (e.g., LOCTITE #567)

c Thread locking compound (e.g., LOCTITE #272)

c A gasket sealant or replacement gasket for your third member.

c A sufficient volume of differential oil to completely refill your

housing. (See the ARB Air Locker Operating and Service Manual

for recommended lubricants)

c A soap and water mixture to test for air leaks.

c Teflon paste.

1 2 3 4 5 6 7 8 9 10 11 ... 37 38

Sin comentarios

Arb RD87 Manual de usuario Pagina 6