Part Number: 3410100 Description: ARB “DAKAR” WINCH BAR TO SUIT TOYOTA LAND CRUISER 60 SERIES WARNING ♦ When installed in accordance with thes
FITTING REQUIREMENTS REQUIRED TOOLS FOR FITMENT OF PRODUCT: Basic tool kit Drill and 10mm drill bit Test lamp HAVE AVAILABLE THESE SAFETY
Last Rev Date: 26/05/2006 Page 3 of 9 Fitting instructions# 3783204Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document
FITTING PROCEDURE 1. Place the bull bar on a suitable surface or stand and fit the indicators using the hardware provided in the indicator kit.
FITTING PROCEDURE NOTE: IF NOT FITTING A WINCH PROCEED TO STEP 11 3. For low mount winches below 10000lb capacity, remove the ten cap screws from
FITTING PROCEDURE 7. Using a 12mm drill bit, drill two new holes in the roller fairlead 20mm below the original holes. 8. Fit the roller fai
FITTING PROCEDURE 11. Fit the licence plate to the bull bar using two M6 x 16mm bolts, M6 flat washers and M6 flange nuts. 12. Fit the left an
FITTING PROCEDURE 14. Fix the mounting bracket to the chassis using four ½” x 1 ½” bolts, eight ½” flat washers, four ½” spring washers and four ½
19. With the bull bar fitted and all bolt tightened, wire the indicators and winch. (if fitted) Use a test lamp to find the correct wires for the in
Comentarios a estos manuales